While I知 at it - anyone have a 3/8 crowfoot flare I can borrow?

Mustang Australia

Author Topic: While I知 at it - anyone have a 3/8 crowfoot flare I can borrow?  (Read 889 times)

Offline jiffy

  • Blue Printed
  • ****
  • Posts: 1938
  • Location: Melbourne
I致e taken my booster in and out and failed to tighten the rear-most brake line on the distribution block. Before I go buy one, thought I壇 ask if anyone near Rowville VIC had one I could borrow for 10 minutes....
« Last Edit: February 09, 2019, 10:08:01 PM by jiffy »
Black '69 CJ 4SPD car under contruction
Black 2002 SVT Cobra - 2003 Terminator Clone
Black 63.5 Galaxie 4SPD fastback

Offline 69candy

  • Worked
  • ***
  • Posts: 647
Re: While I知 at it - anyone have a 3/8 crowfoot flare I can borrow?
« Reply #1 on: February 10, 2019, 04:45:29 PM »
Just cut a ring spanner with an angle grinder

Offline sms777

  • Worked
  • ***
  • Posts: 453
Re: While I知 at it - anyone have a 3/8 crowfoot flare I can borrow?
« Reply #2 on: February 10, 2019, 06:36:43 PM »
Just cut a ring spanner with an angle grinder

:thumb:....Make sure it's a Snap-on spanner.....that's all they good for. :grin:
Click Banner


Offline jiffy

  • Blue Printed
  • ****
  • Posts: 1938
  • Location: Melbourne
Re: While I知 at it - anyone have a 3/8 crowfoot flare I can borrow?
« Reply #3 on: February 18, 2019, 12:02:35 AM »
Ok, bought a set....
Black '69 CJ 4SPD car under contruction
Black 2002 SVT Cobra - 2003 Terminator Clone
Black 63.5 Galaxie 4SPD fastback

 

Visit Custom Mustangs